| CES 287 Specifications Input:4 to 20 mA into 250 ohms Output:4 to 20mA into 800 ohms 0 to 5 volts into 1K ohms 0 to 10 volts into 2K ohms Control Mode:Auto compensating reset Proportional Band:1 to 100% Rate:.08 to .8 second/% Hysteresis and Deadband:Less than .001% Repeatability:Less than .01% FS Windup:3 seconds maximum Termination:Screw terminals Power: 90 to 120VAC @ 2.4VA Max. Operating Temp:0 to 55 C DISPLAYS: Process:3 1/2 digit .3" LED used to display the process under control Setpoint:3 1/2 digit .3" LED used to display the setpoint Output:2 1/2 digit .3" LED used to display output Controls: Setpoint: Used to set desired process control level. Used to set sensivity of controller. Rate: Used to set maximum rate of change of the output. Please Note: The CES 287 Controller is available in almost any standard input/outpt configuration.Others are available upon request, check at time of ordering. ORDERING INFORMATION CES 287-1-2-3 1. Output V: Voltage out I:current out 2. Desired minimum reading (4 mA)* 3. Desired Maximum Reading(20mA) PIN ASSIGNMENTS: 1. 120 VAC Line Power 10. Remote Analog Set Point Input (1 to 5 2. No Connection volt. Used when cascading CONTROLLERS) 3. 120 VAC Neutral 11. Action control 4. No Connection 12. Remote Manual/Auto Control Input- Connecting 5. Analog Common (Ground) this pin to pin 5 in the remote mode causes 6. Setpoint the controller to operate in a manual mode. 7. Process Input 13. Output hold 8. Output Analog Output (1 to 5 volt) 14. Controller Output 9. No Connection 15. +24 VDC APPLICATION NOTES:
DIMENSIONS:
|
